INVESTIGATION OF DEEP COLD ROLLING EFFECTS ON THE BENDING FATIGUE OF BRASS C38500

Authors

  • DANIEL MOMBEINI DEPARTMENT OF MECHANICAL ENGINEERING, NAJAFABAD BRANCH, ISLAMIC AZAD UNIVERSITY, NAJAFABAD, IRAN / MODERN MANUFACTURING TECHNOLOGIES RESEARCH CENTER, NAJAFABAD BRANCH, ISLAMIC AZAD UNIVERSITY, NAJAFABAD, IRAN
  • AMIR ATRIAN DEPARTMENT OF MECHANICAL ENGINEERING, NAJAFABAD BRANCH, ISLAMIC AZAD UNIVERSITY, NAJAFABAD, IRAN / MODERN MANUFACTURING TECHNOLOGIES RESEARCH CENTER, NAJAFABAD BRANCH, ISLAMIC AZAD UNIVERSITY, NAJAFABAD, IRAN

Abstract

IN THE CURRENT STUDY, THE EFFECTS OF DEEP COLD ROLLING (DCR) PROCESS ON THE BENDING FATIGUE BEHAVIOR OF BRASS C38500 ARE INVESTIGATED. UNILATERAL ROTARY BENDING FATIGUE TESTS WERE CONDUCTED BY AN AUTO-MATIC DEVICE ON THE BASIS OF MOORE ROTARY BENDING INSTRUMENT. THE TREATMENT WAS DONE FOR VARIOUS ROLLING DEPTHS (ROLLING FORCES) AND ONE REPEATED PASS TO FIND THE MOST EFFECTIVE CONDITIONS. IT WAS FOUND THAT ROLLING DEPTH OF 75 ΜM HAD THE BEST RESULTS AND COULD IMPROVE THE FATIGUE LIFE ABOUT 19% AND 300% FOR HIGH AND LOW CYCLE FATIGUE REGIMES, RESPECTIVELY. AT THE END, THE RESULTS WERE DISCUSSED MORE USING BOTH MICROSCOPIC EXAMINATIONS AND FINITE ELEMENT (FE) SIMULATIONS IN ABAQUS.

Author Biography

AMIR ATRIAN, DEPARTMENT OF MECHANICAL ENGINEERING, NAJAFABAD BRANCH, ISLAMIC AZAD UNIVERSITY, NAJAFABAD, IRAN / MODERN MANUFACTURING TECHNOLOGIES RESEARCH CENTER, NAJAFABAD BRANCH, ISLAMIC AZAD UNIVERSITY, NAJAFABAD, IRAN

DEPARTMENT OF MECHANICAL ENGINEERING, NAJAFABAD BRANCH, ISLAMIC AZAD UNIVERSITY

NAJAFABAD, ISFAHAN, IRAN 

 

Downloads

Published

2018-02-05

Issue

Section

Articles